Here are the Linux commands I used in the Multiple Klipper Instances on Pad7 video. You should be able to copy and past them directly into Putty. https://youtu.be/Dxjh4iVUL-4 Install...
Posts by Rob
Over-extrusion in 3D printing occurs when the printer deposits more material than is needed to create the desired object. This can happen for a number of reasons, including high-temperature...
Common Mistakes Beginners Make In 3D Printing And How To Avoid Them
Learning through trial and error is very effective, but if you can avoid the errors by doing a bit of extra research, you’ll save yourself time and money. Here are some of the most basic...
Selling 3D prints can be a multimillion-dollar business if you scale it correctly. It could also be a few hundred dollars of side income if you have a good sense of how to run the business. But...
One of the most irritating things for me is when I’ve set everything up for a new print, only to find that the nozzle is too high or the bed is too low. So here’s an article to make sure you...
A garage makes for an excellent 3D printing room because you can close it off from pets and children. You’re also less likely to hear it if you’re printing a job overnight. But there are a few...