3DPrintscape video
Z-Offset Wizard: Set Nozzle Height and Fix First-Layer Problems
Use the Marlin Z-Offset Wizard to establish nozzle height, then verify the first layer with babystepping and a controlled test print. Learn the signs of a nozzle that is too high, too low, or facing a different bed-leveling problem.
Continue watching
Calibration & Slicer Settings series
The next video in this series builds on the same machine and workflow, so you can move from the initial setup to the next real-world result without hunting for it.
Next in the series
Cura First Layer Settings: Fix Adhesion, Height, and Initial-Layer Problems
Companion guide
Need the full written guide?
The companion article expands on this video with the details that are easier to reference while you set up, choose, troubleshoot, or compare.